Thursday, April 20, 2017

a jointer fence

It can be extremely dangerous to pass short pieces of wood across a jointer. For jointing a single piece, a hand plane works best. When needing to accurately join lots of pieces, setting up on the router table gives a way to safely join thin small stock while keeping the fingers a safe distance from the cutter. In this case, the router bit is almost completely buried in the fence and therefore almost completely inaccessible to the finger tips if one was to slip.

The fence itself is formed with two parallel planes with their intersection being at the cutting edge of the bit. This set-up allows shallow cuts to be made, leaving the work-piece true on one edge.

This fence is designed to take passes of just under 1/16 in. at a time. The jointer fence is quickly made from just a stick of hardwood. A through bolt and wing nut secure one end and a "C" clamp the other.

I had tried to interest a magazine in this technique, and may try again.

Make and create.

No comments: